No. 4 Knife Chip Carving PA31-01 The slotted wheel needs to

The slotted wheel needs to be “dressed” occasionally with 60 grit sandpaper

7/64″x3/8″

Mortise chisels and bits are replacement bits for the Delta Mortising Attachment and other similar units

The 3/8"-16 TPI x 3-1/2"-long stems are installed in base units and easily adjusted with a screwdriver from the top or a wrench at the hex nut bottom

No. 4 Knife Chip Carving PA31-01 The slotted wheel needs toDesigned for deep, smooth cuts and consistent chip removal, the pfeil No. 4 Chip Carving Knife is built for both beginners and seasoned woodcarvers. Forged from special alloy tool steel, this blade stays sharp and precise, thanks to its Swiss manufacturing standards. The hardwood handle is shaped for a comfortable grip, allowing hours of carving without hand fatigue. Pre sharpened and Rockwell rated at 5760, its ready to take on intricate projects and